Charge Controller Victron BlueSolar PWM Light 12/24V 5A

Features:

• Charge output with low battery disconnect function
• Light controlled, only a timer
• Two-digit display and seven segments for a quick and easy configuration of the load output function, including the timer setting.
• Battery charge in three stages (constant current, constant voltage, slow charge), non-schedulable.
• Departure of charge protected against overloads and short circuits.
• Reverse polarity protection for solar system and/or battery.
• automatic system voltage detection
• Automatic charge disconnection

Features:

• Battery voltage 12/24 V
• Maximum solar voltage 28 V / 55 V (*1)
• Own consumption
• Charge output: manual control + low voltage off
• Protection: reverse polarity in the battery (functional), short circuit of output, overtemperature
• Overload protection: off after 60 s with a load of 130 %
• Overload protection: off after 5 s to 160 % load
• Overload protection shortcut: off immediately
• Ground: Common Positive Land
• Operating temperature -20 to +50°C (full charge)
• Humidity (without condensation): Max 95%

Battery:

• "constant" load voltage (absorption): 14,2 V / 28,4 V (*2)
• "floating" load voltage (floating): 13,8 / 27,6 V
• Low voltage charge off: 11,2 V/22,4 V
• Reconnection of the charge after low voltage: 12.6 V / 25.2 V (manual) / 13,1 V / 26,2 V (automatic)

*1) To 12 V, use 36-cell solar modules.
A 24 V, use solar modules with 72 cells or 2x 46 serial cells.

*2) 2 hours after reaching constant voltage, the regulator changes to the lowest float voltage level.Each time the battery voltage is less than 13 V, a new charging cycle is activated.