- -39%
Büttner Elektronik MT 130 full solar system CDS Power Line 130 Wp
type of solar systems | monocrystalline |
Dimensions (LxAnxAl) | 1449x530x66mm |
performance | 130 Wp |
number of modules | 1 piece |
daily production | 570Wh |
Full CDS Power Line systems include all installation accessories.Each system is equipped with high quality individual components in a high quality design.All CDS Power Line solar modules are equipped with the best high-performance monocrystalline cells available on the market.
The absolute maximum performance is guaranteed in a small area, even in the most difficult operating conditions.Solar modules are installed in TÜV approved supports.These are attached to the roof of the vehicle with the attached adhesive game (provided and approved by TÜV).
The outdoor cable is UV-resistant and, like the inside cable game, resistant to all environmental influences.The connection of the cable to the interior is made through a raisins at water pressure.The wiring is designed so that the system can be expanded at any time with a solar module of the same power.Solar control can also process the additional output.
All complete systems (up to a maximum of 15 A) are also equipped with an EBL cable set and are therefore state-of-the-art.The assembly game is complemented by the necessary assembly material and the detailed assembly instructions.
The Smart Solution Pay instead of screwing!
No one likes to unnecessarily pierce mounting holes on the roof of his motorhome.In addition, it makes little sense, as the thin skin of the ceiling with its insulation does not guarantee a high resistance of the screw anyway.That's why we built high-quality supports 20 years ago and developed a system to safely paste them to the vehicle's roof without drilling.
Then, solar modules are bolted to these roof wings and can also be easily changed by changing the vehicle.The roof spoiler and the ceiling duct are not made of ABS material, but of high quality polyurethane (PUR).Therefore, they are extremely weather resistant and will last the entire life of the caravan.To avoid the noise of the wind and the floating forces, our system was also tested and optimized in the wind tunnel.Since the attachment system itself complies with the strict DIN standard, the system has been approved by the TÜV to glue on motorhome roofs.More information
High performance in little space
From a technical point of view, the CDS POWER LINE solar modules are the measure of everything in the construction of motorhomes.Absolute superior performance, even in the most adverse operating conditions, is achieved through an innovative glass surface in connection with selected high-performance cells.However, 36 of these high-performance monocrystalline cells are not connected, as usual, but 44. Each individual cell is also connected to a special cell diode to ensure that the maximum output power can also be achieved when the solar module is partially shaded.
Since CDS modules are built with 44 high-performance cells, a MPP solar controller should always be used.Due to the increased output voltage of CDS modules, this ensures optimal performance in each application area.With this control technology, you can always achieve the highest performance when the module voltage is and remains very high, even at high outdoor temperatures.The CDS POWER LINE solar modules in combination with an MPP solar controller reach the highest performance values in each climate zone in the smallest area, even under unfavourable weather conditions.
more details
- Suitable for AGM LiFePO4 + Gel
- Performance advantages in unfavourable weather conditions
- Test winner: Best solar system with unfavorable climate and partially covered sky
- mpp control technology
- Specially developed for tourism vehicles.
- Solar modules for mobile homes and caravans are requested differently than those of domestic systems!For mobile use, connection boxes should be water pressure-threatening (air flow) and welded connections should be specially designed for the vibrations produced.The construction of the frame also requires a special design to compensate for the torsion and floating forces that may occur.
- Heavy and mounting: TÜV tested + approved
- The clamping system has complied with the strict DIN standard and has been approved by the TÜV to glue on motorhome roofs.
- Removable solar module
- When the vehicle is sold, the solar module can be removed from the base support and reinstalled in the new vehicle.
- Small area / high performance
- Extremely high performance through selected raw material
Scope of delivery(ready to install with all the necessary components for mounting on the roof)
- 1 or 2 solar modules CDS Power Line
- 1 or 2 spoiler profile games
- 1 x ceiling duct (printable)
- 1 x presses (impermeable)
- 1 x MPP load controller (see below)
- 1 * cable connector bar
- 1 adhesive game.
- 1 UV/exterior cable game.
- 1 cable/interior game
- 1 EBL cable game (depending on performance)
- 1 mounting material.
- glue instructions
- Assembly instructions
You might also like